Home › Frigidaire › Washers › E68
Frigidaire Washer E68 Error Code
Water heater fault on Frigidaire washers.
FrigidaireAll Frigidaire washer codes
On front-loaders with a built-in water heater, the control found a fault in the heater circuit: current is leaking from the heater to ground, or the heater's fuse has opened. The heater or the control board usually needs replacing.
Compatible models
Only Frigidaire front-loaders with an internal heater, such as the FAFW4011LB and FAFW4221, the Affinity ATF7000FE and the Affinity 6000 and 7000 series.
Also shown as
Related heater codes include E66 (heater relay), E71 (wash water temperature sensor) and E74 (wash water not heating).
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Frigidaire washer codes.
How to fix Frigidaire E68
Try a cold wash
Run a cold-water cycle with no extra heat options to see if the washer finishes. That gets a load done; it doesn't fix anything.
Reset the washer
Power off for 5 minutes, then start a quick cycle and watch the display.
When to call a technician
Heater faults involve mains-voltage parts inside the cabinet, so call a technician if E68 returns.
Parts linked to E68
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the E68 code?
Only Frigidaire front-loaders with an internal heater, such as the FAFW4011LB and FAFW4221, the Affinity ATF7000FE and the Affinity 6000 and 7000 series.
Can I fix Frigidaire E68 myself?
Only the basic checks. You can safely try the steps above, but E68 usually points to a part or fault that needs a technician.
Other Frigidaire washer codes
- E11Washer is taking too long to fill
- E21Washer is draining too slowly
- EF1Drain pump is clogged
- EF2Too many suds
- E13Water or air leak detected
- E31Pressure sensor not reporting
- E35Overfill detected
- E41Door or lid reads as open
- E48Door lock circuit fault
- E52Drive motor or speed signal fault
- E5AMotor control board overheating or not communicating
- E75Water temperature sensor fault
- E91Control panel communication fault
- EA2Power supply out of range
- EF8Button stuck
- E4Top-loader out of balance
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.