Frigidaire Dishwasher Error Codes

All 11 Frigidaire dishwasher codes

• i10Low fill detected
• i20Didn't drain completely
• i40 / iF0Clogged filter or sump
• i30Leak or overflow in the base pan
• i50Drain or wash motor problem
• i60Water heating problem
• iC0Electronic control problem
• PFPower was lost
• CL / CdDoor not latched
• Hd / HOHeating water before washing
• Status lights flashing after drainPossible shorted keypad

About Frigidaire dishwasher error codes

Frigidaire is an American appliance brand owned by the Swedish Electrolux Group. Frigidaire codes are usually shown on the display panel, and some models report faults through blinking lights instead.

How to read Frigidaire dishwasher codes

Display models show a short code such as i20 or PF in the status window. Basic models with no numeric display flash their indicator lights in a pattern instead, and those patterns are covered on this page too.

Most codes clear when you press Cancel (or Start/Cancel), or when you switch off the breaker for about 5 minutes. A plug-in unit can be unplugged for a few minutes instead. If a code comes straight back after that, Frigidaire's advice is to call its customer care line or book service, and the model number on the label at the edge of the door will speed that up.

Of the 11 codes on this page, 5 usually have a simple fix you can do yourself, and 4 usually need a technician. Each guide says which is which, so you don't pay for a service call you don't need, and you don't attempt a repair that isn't safe.

Dishwasher parts guide

All Frigidaire appliances

Before you start

• Write down your model number. It's on a sticker, usually inside the door or lid, on the frame, or on the back or side panel. Parts and some code meanings depend on it.
• Try a reset. Unplug the dishwasher or switch off its breaker for 10 minutes. This clears many one-off glitches without tools.
• Clean the filter at the bottom of the tub. A clogged filter is behind many drain and wash codes.