Home › KitchenAid › Dishwashers › FAE5 / F10E5
KitchenAid Dishwasher FAE5 / F10E5 Error Code
Diverter leak on KitchenAid dishwashers.
KitchenAidAll KitchenAid dishwasher codes
KitchenAid ties this code to a leak at the diverter. Water getting out around that area can show up under the dishwasher.
Compatible models
Same scope as the diverter valve error: KitchenAid dishwashers with a diverter, no model numbers published.
Also shown as
FAE5 and F10E5 are the same fault written two ways.
Difficulty
Start with the safe checks below; a worn part may need replacing.
Not sure you are reading the code right? See how to read KitchenAid dishwasher codes.
How to fix KitchenAid FAE5 / F10E5
Check under the dishwasher
Switch off power at the breaker, then pull the toe kick and look for water on the floor or the base pan. Snug any loose water connections you can reach.
Clear the code and restart
Restore power, press Cancel twice and start a fresh cycle. Watch the first few minutes for drips.
When to call a technician
If the code returns or you find water you can't trace to a fitting, schedule service to check the diverter seal.
Parts linked to FAE5 / F10E5
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
Frequently asked questions
Which KitchenAid models show the FAE5 / F10E5 code?
Same scope as the diverter valve error: KitchenAid dishwashers with a diverter, no model numbers published.
Can I fix KitchenAid FAE5 / F10E5 myself?
Often. The first steps above are safe checks a homeowner can do. If they don't clear FAE5 / F10E5, the cause is likely a worn part that needs replacing.
Other KitchenAid dishwasher codes
- F9E1Long drain (water not pumping out)
- F9E2Drain motor error
- F8E4Water found in the drip tray
- F8E5Fill valve stuck open
- F8E2Fill valve electrical fault
- H2ONo water detected
- F7E2Wash motor error
- F6E1User interface or main control error
- F6E3Too many suds
- F6E4Float switch error
- F4E2 / F4E3Heating system error
- F3E2Thermistor or OWI sensor fault
- F1E1Control module fault
- F1E2 / F2E2Main control communication error
- F2E1Stuck key or console error
- FAE4 / F10E4Diverter valve error
- Sanitize light flashingSanitize temperature not reached
- Control lock light flashingControls locked or asleep
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.