Home › Whirlpool › Dishwashers › F9E2
Whirlpool Dishwasher F9E2 Error Code
Drain motor error on Whirlpool dishwashers.
WhirlpoolAll Whirlpool dishwasher codes
Whirlpool lists this as a drain motor error. Its own troubleshooting starts with the drain path (disposer, knockout plug, drain hose), so clear those before you assume a part has failed.
Compatible models
Whirlpool doesn't list affected models for F9E2. It's part of the F/E code set on its dishwashers with electronic controls.
Also shown as
Clean light: 9 flashes, pause, 2 flashes. The older Sears PartsDirect table says the diverter motor is stuck on.
Difficulty
Start with the safe checks below; a worn part may need replacing.
Not sure you are reading the code right? See how to read Whirlpool dishwasher codes.
How to fix Whirlpool F9E2
Check the drain path
Kill the power first. Then straighten any kinks in the drain hose and make sure it runs inside the cabinet frame, clear the disposer or sink drain, and on a newly installed disposer check that the knockout plug was removed.
Reset the control
Restore power after at least 30 seconds off and start a cycle. Watch whether it drains at the end of the first fill.
When to call a technician
If F9E2 comes back after a reset, book service. The drain motor or control board needs testing.
Parts linked to F9E2
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
Frequently asked questions
Which Whirlpool models show the F9E2 code?
Whirlpool doesn't list affected models for F9E2. It's part of the F/E code set on its dishwashers with electronic controls.
Can I fix Whirlpool F9E2 myself?
Often. The first steps above are safe checks a homeowner can do. If they don't clear F9E2, the cause is likely a worn part that needs replacing.
Other Whirlpool dishwasher codes
- F9E1Long drain (slow or no drain)
- F8E1 / H2ONo water detected
- F8E2Fill valve electrical error
- F8E4Water in the drip tray
- F8E5Fill valve stuck open
- F6E3Too many suds
- F6E4Water float switch fault
- F7E2Wash motor error
- F4E2 / F4E3Heating error
- F3E2Temperature or soil sensor fault
- F6E1Control panel or main control error
- F1E1Control board fault
- F1E2 / F2E2Control communication error
- F2E1Stuck button or console error
- FAE4 / F10E4Diverter valve error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingLoad was not sanitized
- Control lock light blinks 3 timesControls are locked
- All cycle and option lights flashingCycle paused (door opened)
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.