Home › Whirlpool › Dishwashers › F8E2
Whirlpool Dishwasher F8E2 Error Code
Fill valve electrical error on Whirlpool dishwashers.
WhirlpoolAll Whirlpool dishwasher codes
The control has found an electrical problem with the water inlet (fill) valve. A loose connection or a burned-out valve coil is the likely cause.
Compatible models
It can appear on Whirlpool dishwashers using the F/E fault system; there's no published model list.
Also shown as
Clean light: 8 flashes, pause, 2 flashes. The older Sears PartsDirect table lists F8E2 as a drain pump electrical problem.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Whirlpool dishwasher codes.
How to fix Whirlpool F8E2
Look for water at the valve
Turn off the dishwasher's water supply and switch off its breaker (or unplug it if the plug is dry and nowhere near water). Take off the toe kick panel, slide out the drip tray and look for water around the inlet valve connection. Dry anything you find and note where it came from.
Reset the control
Restore water and power after 30 seconds and try a cycle.
When to call a technician
If F8E2 comes back after a reset, book service to test the inlet valve and its wiring.
Parts linked to F8E2
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Whirlpool models show the F8E2 code?
It can appear on Whirlpool dishwashers using the F/E fault system; there's no published model list.
Can I fix Whirlpool F8E2 myself?
Only the basic checks. You can safely try the steps above, but F8E2 usually points to a part or fault that needs a technician.
Other Whirlpool dishwasher codes
- F9E1Long drain (slow or no drain)
- F9E2Drain motor error
- F8E1 / H2ONo water detected
- F8E4Water in the drip tray
- F8E5Fill valve stuck open
- F6E3Too many suds
- F6E4Water float switch fault
- F7E2Wash motor error
- F4E2 / F4E3Heating error
- F3E2Temperature or soil sensor fault
- F6E1Control panel or main control error
- F1E1Control board fault
- F1E2 / F2E2Control communication error
- F2E1Stuck button or console error
- FAE4 / F10E4Diverter valve error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingLoad was not sanitized
- Control lock light blinks 3 timesControls are locked
- All cycle and option lights flashingCycle paused (door opened)
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.