Home › Electrolux › Dryers › E62 / E63 / E64
Electrolux Dryer E62 / E63 / E64 Error Code
Compressor fault (heat pump models) on Electrolux dryers.
ElectroluxAll Electrolux dryer codes
These belong to dryers that use a compressor, the heat pump type. Sears PartsDirect lists E62 as a shorted compressor, E63 as a compressor that isn't running and E64 as a failure in the compressor sensor circuit.
Compatible models
Sears PartsDirect lists these for the Electrolux compact condensing dryer; they only apply to versions built with a compressor (heat pump).
Also shown as
Sears PartsDirect lists them as Ex62, Ex63 and Ex64 for the Electrolux compact condensing dryer.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Electrolux dryer codes.
How to fix Electrolux E62 / E63 / E64
Reset the dryer
Unplug it for 5 minutes, then plug it in and try again. Leave it upright; a heat pump dryer that was laid down or tilted during a move needs to stand for the time the manual states before it runs.
Stop using it if the code returns
Leave the dryer unplugged and call for service with the code noted.
When to call a technician
The compressor is part of a sealed refrigerant system. Only a qualified technician should work on it or open any refrigerant line.
Parts linked to E62 / E63 / E64
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- Compressor
- Wire harness
- Main control board
Order parts by your full model number so they fit.
Frequently asked questions
Which Electrolux models show the E62 / E63 / E64 code?
Sears PartsDirect lists these for the Electrolux compact condensing dryer; they only apply to versions built with a compressor (heat pump).
Can I fix Electrolux E62 / E63 / E64 myself?
Only the basic checks. You can safely try the steps above, but E62 / E63 / E64 usually points to a part or fault that needs a technician.
Other Electrolux dryer codes
- E45Door open
- E21 / E22Condensate drain pump fault
- E31 / E32Humidity sensor failure
- E52 / E54Motor overheated or drum jammed
- E51 / E53Drive motor failure
- E5AMotor inverter board overheated
- E57 / E58 / E59 / E5d / E5E / E5F / E5HMotor drive (inverter) fault
- E70 / E71Temperature sensor problem
- E9EControl panel buttons not responding
- E91Control panel communication failure
- E92 / E98Control panel doesn't match the main board
- EH1 / EH2 / EH3 / E5CPower supply out of range
- E83 / E86 / E87 / EH4 / EHd / EHE / EHF / EF6Main control board failure
Last reviewed 2026-10-20. Codes and steps can vary by model; check your owner's manual.