Home › Amana › Washers › F8 E2
Amana Washer F8 E2 Error Code
Dispenser system problem on Amana washers.
The dispenser system has a fault. Amana's one check is the detergent drawer or detergent cartridge, where dried detergent can build up and block it.
Compatible models
Amana front-load washers. The cartridge check only applies to models with a bulk detergent cartridge.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana F8 E2
Pull out the drawer
Remove the dispenser drawer (or the bulk detergent cartridge on models that have one) and look for thick or dried detergent blocking the compartments.
Wash it out
Rinse the drawer or cartridge under warm water and scrub the channels with an old toothbrush. Wipe out the slot in the washer that the drawer slides into.
Refit and restart
Slide everything back in until it seats fully and start a new cycle.
When to call a technician
Clean dispenser and the code still returns: the dispenser system itself needs a technician's look.
Parts linked to F8 E2
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Amana models show the F8 E2 code?
Amana front-load washers. The cartridge check only applies to models with a bulk detergent cartridge.
Can I fix Amana F8 E2 myself?
Usually, yes. Most F8 E2 problems clear with simple checks you can do at home. Start with the first step above: pull out the drawer.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F21Drain problem
- F5 E1Door switch problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E3Too much water or foam
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- LoCControl Lock is on
- FdSettings returned to factory defaults
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.