Home › Amana › Washers › F5 E1
Amana Washer F5 E1 Error Code
Door switch problem on Amana washers.
The control is reading a fault at the door switch. Most of the time the door isn't fully shut, or a sleeve, a sock or leftover packing material is stopping the switch from closing.
Compatible models
Amana front-load washers (the article isn't tied to a model series). Your owner's manual will confirm.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana F5 E1
Close the door properly
Open the door, look around the opening and the gasket for anything poking out, and push the door shut until it clicks.
Look for packing material
On a new washer, check that no foam or tape from shipping is left near the latch or the switch.
Reset the washer
Unplug the washer for 5 minutes, plug it back in and start a new cycle.
When to call a technician
Door shuts cleanly, nothing in the way, and F5 E1 still appears: the door switch or latch probably needs replacing by a technician.
Parts linked to F5 E1
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
- Washer Won't Spin? 8 Causes and How to Fix Them at Home
A washer that won't spin is usually reacting to an unbalanced load, a low or no-spin setting, too many suds or water it can't drain.
- Washer Won't Start? 8 Things to Check Before Calling for Service
A washer that won't start usually has one of three simple problems: the control lock is on, the door or lid isn't fully latched, or the Start button wasn't held long enough (Whirlpool says up to 3 seconds on many models).
Frequently asked questions
Which Amana models show the F5 E1 code?
Amana front-load washers (the article isn't tied to a model series). Your owner's manual will confirm.
Can I fix Amana F5 E1 myself?
Usually, yes. Most F5 E1 problems clear with simple checks you can do at home. Start with the first step above: close the door properly.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F21Drain problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E2Dispenser system problem
- F8 E3Too much water or foam
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- LoCControl Lock is on
- FdSettings returned to factory defaults
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.