Amana Washer Fd Error Code
Settings returned to factory defaults on Amana washers.
Fd stands for Factory Default. It confirms the washer's options and modifiers went back to factory settings, usually after someone pressed the reset button sequence.
Compatible models
Amana top-load washers (Amana files Fd under its top-load codes). The button sequence may differ on your model, so compare it with the owner's manual.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana Fd
Let it return to standby
Fd stays on for about 3 seconds and then the washer goes to standby. Pick your cycle and options again.
Reset defaults on purpose
To do it yourself: press Power/Cancel, choose Drain and Spin, then within 5 seconds press Extra Rinse, Fabric Softener, Extra Rinse, Fabric Softener.
When to call a technician
Fd showing up on its own, with nobody pressing that sequence: contact Amana service to have the control checked.
Frequently asked questions
Which Amana models show the Fd code?
Amana top-load washers (Amana files Fd under its top-load codes). The button sequence may differ on your model, so compare it with the owner's manual.
Can I fix Amana Fd myself?
Usually, yes. Most Fd problems clear with simple checks you can do at home. Start with the first step above: let it return to standby.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F21Drain problem
- F5 E1Door switch problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E2Dispenser system problem
- F8 E3Too much water or foam
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- LoCControl Lock is on
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.