Home › Midea › Air Conditioners › EL 0C
Midea Air Conditioner EL 0C Error Code
Possible refrigerant leak detected on Midea air conditioners.
MideaAll Midea air conditioner codes
While cooling, the board has decided the system is short on refrigerant. Refrigerant doesn't get used up, so a low charge almost always means a leak somewhere in the line set, the flare joints, or a coil.
Compatible models
Midea's Taiwan code list limits this check to one-to-one (single-zone) systems running in cooling. No model numbers are given.
Also shown as
The old two-character version is EC. Midea's Taiwan list says this check applies to single-zone (one indoor, one outdoor) systems in cooling mode.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Midea air conditioner codes.
How to fix Midea EL 0C
Rule out airflow first
Clean the indoor filters and make sure nothing blocks the indoor grille. Very poor airflow can mess with coil readings.
Don't touch the refrigerant lines
Don't tighten the flare nuts, add refrigerant, or open the service valves. Refrigerant work takes a licensed technician with the right equipment.
When to call a technician
Call a licensed HVAC technician to leak-test the system and recharge it. Running a unit that's low on refrigerant can damage the compressor.
Parts linked to EL 0C
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
- AC Blowing Warm Air? 8 Causes and What You Can Fix Yourself
Warm air from an AC is most often a wrong mode setting, clogged indoor filters, or an outdoor unit that has lost power or stopped.
- AC Freezing Up? Why the Indoor Coil Ices Over and What to Do
An AC that freezes up almost always has too little air moving across the indoor coil, and a clogged filter is the first suspect.
- AC Leaking Water Indoors? 6 Causes and How to Fix Each One
An indoor AC unit that drips is usually dealing with condensate that can't drain away: a clogged drain line, a coil that froze because the filters are dirty, or a unit or drain hose that isn't sloped correctly.
Frequently asked questions
Which Midea models show the EL 0C code?
Midea's Taiwan code list limits this check to one-to-one (single-zone) systems running in cooling. No model numbers are given.
Can I fix Midea EL 0C myself?
Only the basic checks. You can safely try the steps above, but EL 0C usually points to a part or fault that needs a technician.
Other Midea air conditioner codes
- EL 01Indoor and outdoor units have lost contact
- EH 00Indoor board memory (EEPROM) fault
- EH 03Indoor fan speed out of range
- EH 60Room temperature sensor fault
- EH 61Indoor coil sensor fault
- EH 0bIndoor main board and display aren't talking
- EC 07Outdoor fan speed out of control
- EC 53Outdoor air temperature sensor fault
- EC 52Outdoor coil sensor fault
- EC 54Compressor discharge sensor fault
- PC 00Inverter power module (IPM) protection
- PC 01Supply voltage too high or too low
- PC 02Compressor or power module overheating
- PC 04Inverter compressor drive error
- PC 08Over-current protection
- PC 0LToo cold outside to run
- P1Portable AC water tank is full
- E1Portable AC room temperature sensor fault
- E2Portable AC evaporator sensor fault
- E4Portable AC display panel communication fault
- ASWindow AC room temperature sensor fault
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.