Home › Maytag › Washers › F3E1
Maytag Washer F3E1 Error Code
Water level sensing problem on Maytag washers.
The washer can't read the water level in the tub. Maytag puts it down to the control unit or its wiring, so beyond a reset there's little a homeowner can safely do.
Compatible models
Maytag lists F3E1 for its top-load washers, and Sears PartsDirect calls it a pressure sensor fault on the Bravos and Centennial VMW top-loaders.
Also shown as
No other codes are listed for this fault.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Maytag washer codes.
How to fix Maytag F3E1
Check the power connection
The washer should be plugged straight into a working wall outlet, with no extension cord or power strip, and the cord should be undamaged. If you see damage, leave it unplugged.
Reset the control
Do the 5-minute power cut from the top of the page and run a short cycle to see if F3E1 is gone.
When to call a technician
F3E1 back after a reset means booking service so a technician can check the water level sensing parts and wiring.
Parts linked to F3E1
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Maytag models show the F3E1 code?
Maytag lists F3E1 for its top-load washers, and Sears PartsDirect calls it a pressure sensor fault on the Bravos and Centennial VMW top-loaders.
Can I fix Maytag F3E1 myself?
Only the basic checks. You can safely try the steps above, but F3E1 usually points to a part or fault that needs a technician.
Other Maytag washer codes
- F8E1Washer is filling too slowly
- F9E1Washer is taking too long to drain
- F5E1Door or lid switch does not detect it closed
- F5E2Door or lid will not lock
- F5E3Lid lock fault
- LdULid cannot unlock
- F0E5Load is off balance or too large
- SudToo many suds
- F7E1Motor or basket speed problem
- F6E2Control, display or wiring fault
- HCHot and cold hoses are reversed
- OLLoad is too large
- rLItems found during Clean Washer cycle
- F8E2Dispenser system problem
- LOCControl lock is on
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.