Home › Maytag › Washers › F5E2
Maytag Washer F5E2 Error Code
Door or lid will not lock on Maytag washers.
The washer tried to lock the door or lid before the cycle and couldn't. Usually something is blocking the lock, such as clothing caught in the opening or detergent residue built up around the lid lock.
Compatible models
Maytag front-loaders and top-loaders both show F5 E2. Sears PartsDirect lists it as a lid lock fault on Bravos and Centennial VMW top-loaders.
Also shown as
Top-load HE models may show LdL for the same lid lock problem.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Maytag washer codes.
How to fix Maytag F5E2
Check for anything in the way
Open the door or lid and pull out any clothing caught in the opening. On top-loaders, don't let items pile up right under the lid.
Clean the lock area
Unplug the washer. Wipe detergent or softener residue off the lid lock or door latch with a damp cloth, and let it dry.
Clear the code and restart
Plug back in. Front-loaders clear with Pause/Cancel twice and Power once; top-loaders need the 5-minute unplug reset. Then start a new cycle.
When to call a technician
Nothing blocking the lock and F5E2 still returns: Maytag recommends a service visit, where a technician will usually test and, if needed, replace the lock assembly.
Parts linked to F5E2
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
- Front Load Washer Door Won't Open? Why It's Locked and What to Do
A front-load washer keeps its door locked while there's water in the drum, while the drum is still turning, or while the inside is hot, so a door that won't open usually means the washer hasn't drained.
- Washer Won't Spin? 8 Causes and How to Fix Them at Home
A washer that won't spin is usually reacting to an unbalanced load, a low or no-spin setting, too many suds or water it can't drain.
- Washer Won't Start? 8 Things to Check Before Calling for Service
A washer that won't start usually has one of three simple problems: the control lock is on, the door or lid isn't fully latched, or the Start button wasn't held long enough (Whirlpool says up to 3 seconds on many models).
Frequently asked questions
Which Maytag models show the F5E2 code?
Maytag front-loaders and top-loaders both show F5 E2. Sears PartsDirect lists it as a lid lock fault on Bravos and Centennial VMW top-loaders.
Can I fix Maytag F5E2 myself?
Usually, yes. Most F5E2 problems clear with simple checks you can do at home. Start with the first step above: check for anything in the way.
Other Maytag washer codes
- F8E1Washer is filling too slowly
- F9E1Washer is taking too long to drain
- F5E1Door or lid switch does not detect it closed
- F5E3Lid lock fault
- LdULid cannot unlock
- F0E5Load is off balance or too large
- SudToo many suds
- F7E1Motor or basket speed problem
- F3E1Water level sensing problem
- F6E2Control, display or wiring fault
- HCHot and cold hoses are reversed
- OLLoad is too large
- rLItems found during Clean Washer cycle
- F8E2Dispenser system problem
- LOCControl lock is on
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.